Sealing flange and flywheel:
1 Bolt. Replace
2. Crankshaft timing belt sprocket. There should be no oil on the mating surfaces between the timing belt drive sprocket and the crankshaft, and installation is only possible in one position. Remove after dismantling the timing belt
3. Crankshaft Belt Pulley
4. Bolt with washer for poly V-belt and toothed belt pinion for crankshaft. Replace
5. Crankshaft seal. Replace
6. Oil pump. The oil pump housing is a unit with a sealing flange on the belt pulley side. When installing, watch the hub of the driven disk on the crankshaft, it must be installed on the installation bushings
7. Seal. Replace, must be installed on centering bushings
8. Cylinder block with crankshaft. It is prohibited to remove the crankshaft
9. Bolt. Replace, 60 Nm + 90°
10. Flywheel
11. Intermediate shield, do not damage during installation work
12. Bolt. Replace, tighten crosswise to 12 Nm
13. Sealing flange on the side with the gland, lubricate with sealant
[The original article is available on the online resource «audimanual»]