Removal and installation of a combination of devices Indication "dEF" on the trip odometer If the control unit of the instrument cluster recognizes an error in the ROM, then the indication is displayed in the...
Pin assignment coolant temperature sensor connector Pin assignment of connector for coolant temperature display sender G2- / coolant temperature sender -G62- Unlock the service cover from the inside. Unlock the...
Overview of parking aid components 1. Rear warning buzzer -H15-. Under left D-pillar trim 2. Used parking aid -J446-. In the luggage compartment at the rear left under the side trim 3. Parking...
Removing and installing the parking aid control unit Withdrawal Remove the left luggage compartment side trim. Remove screws -1...3-. Remove the mounting plate with hinges. Unscrew bolts -2-. Pull out parking aid...
Removing and installing rear parking aid sensors Withdrawal Switch off the ignition and remove the ignition key. Remove the left luggage compartment side trim. Remove screws -1...3-. Remove the mounting plate...
Anti-theft alarm or siren sound Withdrawal Fitting location: in the luggage compartment at the rear left under the side trim. Switch off the ignition and remove the ignition key. Remove the...
Relay board and fuse box Carefully! On vehicles with the Telematik system, before disconnecting the battery, activate the service mode of the Telematik control unit - radio, telephone,...
Removing the left door splitter connector Press the dust cover -1- in the area indicated by -arrow- and remove it. Unlock door separators -2- and -4- and pull outwards by pressing locking tabs -1- and...
Removal and installation of the alarm switch relay Withdrawal Remove Climatronic air conditioning display and operating unit -E87-. Remove storage compartment. Grab through the opening and disconnect the plug...
Removal and installation of the 6+6-slot relay box Withdrawal Disconnect the ground wire in the battery with the ignition off. Raise the floor mat on the left side of the vehicle. Turn locks -1...3-...
Removing and installing the 3-pin relay box Withdrawal Disconnect the ground wire in the battery with the ignition off. Raise the floor mat on the left side of the vehicle. Turn locks -1...3-...
Disconnecting the right door splitter connector Press the dust cover in the area indicated by -arrow- and remove it. Unlock door separators -1- and -2- and pull outwards by pressing locking tabs -3- and -4-...
Removing and installing the main fuse box Withdrawal Disconnect the ground wire in the battery with the ignition off. Fold covers -2- and -4- aside. Loosen nut -1- and remove cable. Unscrew the nut -3-...