Table of contents: Removal ↓ Installation ↓
Removal
Disconnect the battery ground wire with the ignition off. Press the switch "arrow 1" and simultaneously turn it to the right "arrow 2". Holding the switch in this position, remove the light switch from the switch housing "arrow 3". Disconnect the connectors.
Remove the storage compartment on the driver's side. Unscrew the "arrow" nuts. Remove the 9-slot relay block. Unclip fuse block "2" on the 9-slot relay block. Remove the relays, control units, and then the corresponding relay board.
Installation
Installation is in reverse order, it is necessary to install the storage compartment on the driver's side. Install the light switch. Connect the battery.
Tightening torque:
- Fuse Block to 9 Pin Relay Block; 2 Nm
- 9-pin relay block to central pipe: 2 Nm
[The original article is available on the website «Audimanual.ru»]