Manual gearbox 02T car Audi A2

Marking of the manual gearbox 02T
5-speed, manual transmission 02T is installed on the Audi A2 2001 in combination with a 4-cyl. engine with injection. Location at the checkpoint Letter...

Clutch drive repair
Instructions. If the clutch master cylinder or slave cylinder must be replaced due to a suspected fault, the clutch drive must first be checked. Disconnect the...

Clutch pedal assembly — design description
Clutch pedal assembly: 1. Engine shield with mounting for support cushion and master cylinder 2. Gasket. Always subject to replacement 3. Clutch pedal mounting...

Hydraulic clutch drive system
Hydraulic clutch drive system: 1. Brake fluid reservoir 2. Hose 3. Clamp for removing the main line; remove the clamp until it stops 4. Master cylinder 5. Nut,...

Removal and installation the slave cylinder
Removal First, you need to check whether the car has a radio with coding. If yes, you should request a security code. Disconnect the ground wire from the...

Repair of the clutch release mechanism
1. Release bearing. Do not wash the bearing, only wipe it. Replace bearings that make a loud noise, lubricate the contact point on the release lever with MoS2...

Clutch repair
Instructions. Before replacing the clutch disc and pressure plate, take into account the requirements in the section "Transmission diagnostics, complaints...

Removal and installation the clutch
Removal Remove the CP. Insert stop "3067" for loosening and tightening bolts. Loosen bolts little by little, crosswise. Remove pressure plate and clutch disc....

Mounting position of the gear shift mechanism
Mounting position of the gear shift mechanism: Arrow A. Switch movement Arrow B. Move selection 1. Gear shift lever 2. Intermediate lever 3. Cable shift drive...

Repair of the shift lever and shift mechanism housing
Instructions: Lubricate the bearing and sliding surfaces with polyurea grease "G 052 142 A2". 1. Lock washer 2. Bushing 3. Pressure spring 4. Bushing 5. Bolt,...

Removal and installation of cable drives
Lubricate the sliding support surfaces with polyurea grease "G052 142 A2". 1. Selector cable drive. Lubricate the area of the pressure element with silicone...

Removal and installation the gear shift drive
Removal Disconnect the ground wire from the battery with the ignition off. Unlock the gear selector and shift cable lock as described below. Pull the shift...

Adjusting the gear shift mechanism
Instructions. The following points are the initial conditions for correct adjustment: perfect execution of the control elements and the transmission of the...

Removal and installation the gearbox
Removal Disconnect the battery ground wire with the ignition off. Remove the rubber seal on the water drainage box. Remove the windshield wiper arm and...

Checking the transmission oil
Unscrew the oil condition control bolt "arrow". The oil level is correct if the gearbox is filled to the lower edge of the oil filler hole. Screw in the screw...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2(1999-2005)