1. Lock washer
2. Bushing
3. Pressure spring
4. Bushing
5. Bolt, 6 Nm
6. Lid
7. Soundproofing
8. Bearing insert. Clip into sound insulation
9. Shift lever guide
10. Shock absorbing washer
11. Selector
12. Soundproofing. Install on the gearshift mechanism housing
13. Shift mechanism housing
14. Support sleeve. Can be installed in one position only
15. Support finger
16. Guide bush. Install on gear shift housing
17. Pressure spring
18. Selector corner
19. Bolt, 6 Nm
20/21. Bolt, 9 Nm
22. Mounting plate
23. Lock washer
24. Cable drive of the selector to the selector corner
25. Shift cable. Place on selector guide
26. Support sleeve. Can be installed in one position only
27. Lock washer
Removal and installation the lock washer
To remove and install the lock washer "A", move the gearshift lever "in the direction of arrow A" and at the same time move the spacer sleeve down to the stop with a screwdriver "in the direction of arrow B".
Instructions. When pressing on the spacer sleeve, it must not be tilted. Carefully loosen the seat for the lock washer on the gearshift lever.