Diesel engine lubrication system 1.4L car Audi A2

Engine lubrication system — design description
Instructions. If during engine repairs large quantities of metal shavings or wear products were found in the engine oil, the lubrication channels should be...

Removal and installation the oil pan
Removal Remove the dipstick. Remove the noise insulation of the "arrow". Place a waste oil collection unit under the engine "V.A.G 1782". Drain the oil....

Oil pump and crankshaft frame — design description
Oil riacoc and crankshaft frame: 1. Cylinder block 2. Oil nozzle for piston cooling. Observe the installation position: turn the oil nozzle counterclockwise...

Removal and installation the oil pump
Removal Remove the oil pan. Unscrew the bolts "arrows". Unlock the 5 fastening brackets and remove the oil separator. Press the chain tensioner "arrow" down...

Oil filter bracket with oil cooler
Oil filter bracket with oil cooler: 1. Threaded plug, 25 Nm 2. Gasket. Replace 3. Oil radiator. Various designs. Observe the instructions 4. Gasket. Replace 5....

Removal and installation the oil filter bracket
Removal Remove the hood. If present, loosen the bracket. Remove the engine cover. Remove the sound insulation underneath. Loosen the "arrow" cover a few turns,...

Removal and installation the oil pressure sensor
Removal Remove the hood. Disconnect the "arrow" connector from the oil pressure sensor "F1". Unscrew the oil pressure sensor. Installation Installation in...

Checking oil pressure and oil pressure sensor
Oil level is normal. Engine oil temperature is approximately 80°C. Remove oil pressure sensor "F1". Connect a pressure gauge to measure oil pressure "V.A.G...

Checking the oil level
Oil temperature is not less than 50°C. The car is on a flat horizontal surface. Wait a few minutes after stopping the engine to allow the oil to drain back...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2(1999-2005)