Removal and installation the oil pressure sensor (Audi A2)

Table of contents: Removal ↓ Installation ↓

Removal

Remove the hood. Disconnect the "arrow" connector from the oil pressure sensor "F1".

Unscrew the oil pressure sensor.

Installation

Installation in reverse order, replacing the sealing cuff. Check the oil level. Tightening torque: Oil pressure sensor "F1" to the oil filter bracket: 20 Nm.

(The original article is available on the website: audimanual)

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Lubrication system

Removal and installation the oil filter bracket
Oil filter bracket with oil cooler
Removal and installation the oil pump
Oil pump and crankshaft frame — design description

Checking oil pressure and oil pressure sensor
Checking the oil level

Similar articles on other Audi car models:
Coolant Temperature Sensor — Removal and Installation Audi 80 B3 (1986-1991, petrol)
Coolant level and brake lining wear monitoring, oil pressure… Audi 100 C3 (1982-1990, diesel)
Checking the oil pressure and oil pressure gauge sensor Audi A3 Type 8L (1996-2003)
Checking oil pressure and pressure sensor Audi A4 B6 (2000-2006)
Checking oil pressure and oil pressure sensor Audi A6 C5 (1997-2004)
Engine speed sensor Audi A8 D2 (1994-2002)
Removal the oil pressure sensor Audi Q5 Type 8R (2008-2017)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Audi A2(1999-2005)