Removal and installation the flywheel (Audi A2)

Table of contents: Removal ↓ Installation ↓

Removal

The gearbox is removed. Remove the clutch pressure plate. Use the "3067" locking tool to unscrew the bolts. Unscrew the bolts and remove the flywheel.

Installation

Installation in reverse order, in this case it is necessary to replace the flywheel bolts. Due to the offset holes, installation is possible only in one position. Rearrange the lock "3067" for tightening the bolts. Install the clutch pressure plate.

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Engine repair

Replacing the crankshaft seal
Engine speed sensor
Installing an intermediate shield
Sealing flange and flywheel — design description

Removal and installation the sealing shaft from the gearbox side
Cylinder head — design description
Modification of the cylinder head sealing surface
Sequence and tightening torque of cylinder head bolts