Instruction. Lubricate all support and working surfaces during installation work.
Cylinder head:
1. cylinder head. The seating surface to the camshaft housing must be free of oil and grease. After replacement, replace the coolant and oil
2. Bolt, 20 Nm
3. Engine mount lug
4. Hydraulic compensator. Mark the mounting position for reinstallation Lubricate the work surface with oil
5. Retaining clip, check secure fit, not available separately
6. Valve lever with roller. Mark the mounting position for reinstallation, check the roller bearings for ease of rotation, lubricate the working surface with oil, secure with the safety clip -pos. 5- on the hydraulic compensator -pos. 4
7. Mesh oil filter, installed on the cylinder head. Replace
8. Bolt, 20 Nm
9. Camshaft housing
10. Bolt. Replace, follow the sequence when unscrewing
11. Engine mount lug
12. Bolt. Replace, follow the sequence when unscrewing
13. Cylinder head gasket. Replace. Installation position: The part number points to the cylinder head and must be read on the intake side. After replacement, replace the coolant and oil.
Visitor comments