Disassembling the headlight (Audi 100 C4)

When disassembling, do the following:

Remove the trim above the headlight glass and carefully pry up the mounting brackets with a screwdriver around the circumference of the headlight glass. Depending on the design, there may be 5 or 7 of them.

Remove the headlight glass together with the sealing rubber.

Carefully push the chrome trim away from the reflector and remove it.

Now remove the reflector. For a design without fog lights, carefully pry the reflector out of the mounting rings; for a design with fog lights, unscrew the two adjusting bolts until the reflector is free and can be removed.

If installed, remove the servo motor as described in the next section.

The headlight assembly is carried out in the reverse order. Please note the following:

Do not touch the inside of the reflector with bare hands. To install, carefully press it into the mounting rings or turn the bolts to set it in the correct position

The rubber seal on the headlight glass should always be replaced.

Press the headlight glass mounting clamps into the correct position by hand.

After installing the headlight, you need to check its adjustment in each case.

(This publication is borrowed from the resource: AUDImanual.ru)