Table of contents: Removal ↓ Installation ↓
Removal
Remove the noise insulation screen. Remove the left mudguard. Unscrew bolts -1 and "2" on the power steering pump. Ignore pos. "3".
Where available, remove the hydraulic booster line bracket. Disconnect connectors "1" and "2" on the pump. The bumper is removed in the picture.
Press the "arrow" holders of the wiring harness on the pump. To do this, use the "80.200" release lever. To facilitate removal, use a silicone-free spray if necessary.
Hang the pump with the hoses attached to the shock absorber strut.
Unclip the ventilation hose "1" on the holder "arrow". Remove the flexible tube "2" from the windshield washer reservoir.
Remove screws "1" and "3". Place a receiving tank under the washer reservoir. Disconnect the windshield washer system pipe "5" on the windshield washer water pump. Disconnect connector "4". Remove the windshield washer reservoir "2" from the guide ring.
If available, disconnect the "arrow" plug connector of the low washer fluid level sensor contact "F77". The bumper is removed in the figure.
Installation
Installation is in the reverse order, taking into account the following: the water hose must be fixed with a clearly audible click in the windshield washer water pump connector. Insert the ventilation hose "1" into the mounting bracket and measure the distance "a" (dimension "a" = 3 mm). When installing the pump, pay attention to the corresponding gasket and fastening of the hydraulic pipes. Install the left mudguard.
Tightening torques:
- Windscreen washer reservoir to lock shelf: 3 Nm
- Pump to side member: 23 Nm