Table of contents: Removal ↓ Installation ↓
Removal
The front left washer fluid reservoir in the engine compartment supplies fluid to both the windshield washer system and the headlight cleaning system. Remove the noise insulation screen. Remove the left mudguard. Remove the front bumper. Disconnect connectors "1" and "2" on the pump. Press the "arrow" holders of the wiring harness on the pump.
To do this, use the release lever "80.200". To facilitate removal, use a silicone-free spray if necessary.
Unscrew bolt "1" and nuts "3" on the power steering pump. Ignore pos. "2". Hang the pump with the hoses attached to the shock absorber strut.
Unclip the ventilation hose "1" on the holder "arrow". Remove the flexible tube "2" from the windshield washer reservoir.
Unscrew bolts "1". Place a receiving tank under the washer reservoir. Remove the washer fluid pipe "arrow" from the washer fluid water pump. Disconnect the connectors. Remove the washer fluid reservoir "2" from the guide ring "4". 3. Expansion pin.
Installation
Installation in reverse order, taking into account that the water hose must be fixed with a clearly audible click in the windshield washer water pump connector. Insert the ventilation hose "1" into the mounting bracket and measure the distance "a" (dimension "a" = 3 mm). When installing the pump, pay attention to the corresponding gasket and fastening of the hydraulic pipes. Install the front bumper. Install the left fender liner.
Tightening torques:
- Windscreen washer reservoir to lock shelf: 3 Nm
- Pump to side member: 23 Nm
[Information obtained from this resource «audimanual.ru»]