Lamps are replaced from the engine compartment. Remove the pre-air duct on the right side.
Remove the protective cover from the engine compartment. One or two buttons are visible on the top side (depending on whether fog lights are installed or not). Push button (buttons) down and remove the cover.
Disconnect the plug from the corresponding headlight bulb.
Lift the retaining clip by the two tabs and pull the bulb out of its socket on the headlight. Do not handle the new bulb with bare fingers. When installing the lamp, proceed according to the following instructions:
When installing the H4 lamp (headlight without fog light) put the middle tongues on the upper side.
When installing the H7 lamp (headlight with fog light) place the spouts of the lamp dish vertically on the upper side.
When installing the H1 lamp (fog light) insert both spouts into the reflector. After replacing a headlight bulb, always check the headlight adjustment and correct if necessary. Better to do it in the workshop.
Visitor comments