Order of execution
1. Loosen bolt 24 (see fig. Type 014 Gearshift Control Mechanism) terminal connection of the switching rod with the rocker mechanism 22.
2. Remove the shift knob and cover.
3. Place the shift lever vertically on the 3rd and 4th gear lines.
4. Tighten the terminal connection of the rod with bolt 24, while the gearbox must be in the neutral position.
5. Engage 1st gear.
6. Move the shift lever to the left as far as it will go.
7. Release the lever. It should return to its previous position, while the movement should be from 5 to 10 mm. This should be achieved by moving the hinge of the lever in the longitudinal holes.
8. Engage 5th gear.
9. Move the shift lever to the right as far as it will go.
10. Release the lever. It should return to its previous position, while the movement should be from 5 to 10 mm. This should be achieved by moving the hinge of the lever in the longitudinal holes.
11. Engage all gears one by one. At the same time, pay attention to the effectiveness of blocking the reverse gear.
12. Install the shift lever cover and screw on the handle.
Visitor comments