Power clutch
- 1 - driven disk;
- 2 - pressure plate assembly;
- 3 - bushing;
- 4 - bolt;
- 5 - clutch release bearing;
- 6 - guide sleeve;
- 7 - clutch release fork lever;
- 8 - bolt;
- 9 - return spring;
- 10 - clutch release fork;
- 11 - adjusting sleeve;
- 12 - locknut;
- 13 - cable sheath;
- 14 - clutch pedal;
- 15 - spring retainer
Installing the clutch release lever
- 1 - clutch release fork lever;
- 2 - cable stop sleeve
Order of execution
1. Remove gearbox.
2. Use a screwdriver to remove the spring clips on both sides of the clutch release bearing race.
3. Remove the clutch release bearing from the guide bush.
4. Remove the clutch release bearing from the cage, having previously removed the mounting brackets.
5. Install a new clutch release bearing into the cage and fasten both parts of the cage together with mounting brackets.
6. Install the clutch release bearing assembly with the cage onto the guide bushing.
7. Fix the bearing on the clutch release fork by installing two spring clips.
8. Check the function of the return spring. The clutch release fork under its influence should move the bearing towards the gearbox housing.
9. Check the distance from the clutch release fork lever to the clutch cable thrust bushing. It should be 185 mm. In this case, the clutch pedal must be released. If this distance differs from the specified one, it is necessary to rearrange the lever on the splines of the clutch release shaft.
Visitor comments