Removing the center console cover (release models prior to December 1987)
- 1 - screw;
- 2 - cover;
- 3 - center console
Removing the frame of the center console (release models prior to December 1987)
- 1 - screw;
- 2 - frame;
- 3 - casing
Removing the center console (release models prior to December 1987)
- 1 - screw;
- 2 - center console
Removing the center console (release models since January 1988)
- 1 - clamp;
- 2 - screw;
- 3 - side front upholstery of the console;
- 4 - side rear upholstery of the console
Order of execution
1. Disconnect wire from «negative» battery terminals.
2. Unscrew the gear lever knob.
Release models prior to January 1988
3. Loosen the fastening screw and remove the casing upwards, first sliding it back a little.
4. Take out the ashtray.
5. Unscrew the four fixing screws and remove the console trim from the top latch.
6. Remove the trim panel for the heater control panel.
7. Remove the four screws on the front console mounting.
8. Remove the center console, disconnecting the wires from it if necessary.
9. Install the center console in reverse order.
Release models since January 1988
10. Detach gear lever cover and lift upwards.
11. Pull the four latches to the sides and remove the ashtray.
12. Unscrew the two fastening screws and remove the side front upholstery of the console upwards, after releasing them from the latches.
13. Unscrew the two fastening screws and remove the side rear upholstery of the console up, after releasing them from the clamps.
14. Loosen the console mounting bolts.
15. Remove the center console, disconnecting the wires from it if necessary.
16. Install the center console in reverse order.
Visitor comments