Insert for center console 1. Center console; 2. Front ashtray; 3. Bolt. 2 pcs. 2.5 Nm; 4. Selector; 5. Decorative frame; 6. Coin box; 7. Insert for the center console; 8. Clamp. 6 pcs. Insert into center console
Removing the center console insert
Equipment option with dual-clutch gearbox: set selector lever to position "S". Turn off the ignition. Remove Climatronic control unit -J255-. Carefully push the control lever/gearbox lever seal from the side using a removal wedge -3409- or a small screwdriver -arrows- and bend it upwards.
Apply electrical tape to the center console trim around the center console insert to prevent damage to the surface. Set option with access and start authorization button: If the center console insert is abruptly removed, the locking mechanism of the access and engine start authorization button -E408- may be damaged because the electrical cable to the button is somewhat shorter. Carefully unscrew the center console insert and remove it upwards. Grasp the center console insert -arrow A- from below with your hand and carefully lift it out of the center console -arrow B-.
Disconnect the connectors and carefully remove the center console insert above the automatic transmission control lever/gearshift lever.
Installation in reverse order: insert center console insert until it clicks into place.
Visitor comments