Note. For this adjustment, you must use two wooden stands - bars measuring 50x50x309 mm.
Place stands under the vehicle as shown in the illustration.
Place a load of about 100 kg in the trunk so that the ends of the supports barely touch the body.
Loosen the adjusting bolts 2 of the valve drive rods.
Adjustment of drafts of a drive of the adjusting valve: 1 - welding electrode rod; 2 - adjusting bolts
Block the rocker arm of the control valve with a short rod of a welding electrode with a diameter of 3 mm.
Tighten the adjusting bolts.
Remove the electrode fixing bar and wooden supports.
Visitor comments