Table of contents: Cars with rear drum brakes ↓ Cars with rear disc brakes ↓
Cars with rear drum brakes
Remove the wheel from the desired side.
Remove the cap, cotter pin 1 (see photo) and remove the toothed stopper 2.
Removal the rear wheel hub: 1 - cotter pin; 2 - toothed stopper; 3 - locking washer
Unscrew the hex nut and remove the locking washer 3.
Using a screwdriver inserted through the threaded hole for the wheel mounting bolt, pry up the automatic brake shoe clearance adjustment bar.
Remove the hub, which is made integral with the drum, so that the inner bearing rings do not fall out.
Install the hub in the reverse order of removal, taking into account the following:
- when installing the hub, put universal consistent grease into it;
- adjust the clearance in the hub bearings and replace with a new cotter pin.
Cars with rear disc brakes
Remove the wheel from the desired side.
Remove the caliper assembly from the pad guide and hang it from the body using a service hook without disconnecting the brake hose.
Remove the brake disc.
Remove the cap, remove the cotter pin and the toothed stopper.
Loosen the hex nut and remove the lock washer.
Remove the hub carefully so that the inner bearing races do not fall out.
Install the hub in the reverse order of removal, taking into account the following:
- apply universal grease to the hub;
- adjust the clearance in the hub bearings and replace with a new cotter pin.
Rear wheel hubs: 1 - until January 1988.; 2 - since January 1988.