Selector seal - replacement
1. Remove the oil seal with a screwdriver (photo).
2. Insert a new oil seal.
3. Fill the space between the oil seal lugs with multipurpose grease.
Selector Bushing - Replacement
4. Remove the stuffing box, drive the sleeve into the switching housing with a metal pipe.
5. Insert a new sleeve into the casing in the same direction, install a new oil seal.
Input shaft bearing - removal and installation
6. Remove the baffle from the switch housing. The plate is forged, so a round file may be required to remove the cut.
7. Remove the retaining ring and, using a soft metal drift, tap the bearing into the housing (photo).
8. Insert a new bearing into the casing, install the circlip.
9. Secure baffle in place in housing (photo).
Visitor comments