1. Check the condition of the 5th gear and the 5th driven gear, replace them as needed.
2. If you need to disassemble the synchronizer, first mark the alignment of the sleeve and hub relative to each other, then remove the sleeve, blockers and springs.
3. When assembling the synchronizer, find the alignment marks. The fork groove on the hub must face the 5th gear. After inserting the locking cotters, position the inner spring in one of the cotters, then use a screwdriver to place the springs under the other cotters. Install the outer spring in any wrench with the free end facing the inner spring.
4. Check the condition of the synchronizer ring as described in Chapter 5, install it on the clutch.
Visitor comments