Table of contents: Removal ↓ Installation ↓
Removal
Remove the engine hood. Remove the engine cover "arrows". Remove the noise insulation screen located below, for this, disconnect the crankcase ventilation hose.
Disconnect the water tank. Remove the upper toothed belt cover by releasing the locking clamps "arrows".
Unscrew the "arrow" bolts of the fuel line bracket on the cylinder head cover. Unscrew the cylinder head cover bolts in the sequence "11...1". Remove the bracket together with the fuel lines. Remove the cylinder head cover.
Installation
Install in reverse order, replacing the cylinder head cover gasket if damaged. If the gasket is damaged, replace the cylinder head cover mounting bolts.
Apply a drop of "arrows" sealant to the mating areas of the front bearing cover and the cylinder head (diameter approx. 5 mm). Apply a drop of sealant "arrows" to the mating areas of the rear bearing cover and the cylinder head. Tighten the cylinder head cover bolts in the sequence "1...11".
Tightening torques:
- Cylinder head cover to cylinder head: 10 Nm
- Fuel line to fuel line bracket: 10 Nm