Bearing cap seals 1 and 4 (Audi A2)

Apply a thin and even layer of sealant to surface «1»; sealant.

Apply a thin and even layer of sealant to surface "1"; sealant.

Instructions: Make sure that no sealant gets into the grooves "arrows". Bearing cover 4 is designated as bearing cover "5".

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Audi A2: Engine repair

Next articles

Valve mechanism repair
Removal and installation the intake manifold
Removal and installation of the cylinder head
Removal and installation the cylinder head cover

Replacing the camshaft seal
Removal and installation the camshaft

Similar articles on other Audi car models:
Front and rear crankshaft seals — replacement Audi 80 B3 (1986-1991, petrol)
Camshaft Seals — Replacement Audi 100 C3 (1982-1990, diesel)
Removal and installation the shock absorber strut and wheel… Audi A3 Type 8L (1996-2003)
Checking the drive shaft seals Audi A4 B5 (1994-2001, petrol)
Sliding sunroof seals Audi A6 C5 (1997-2004)
Crankcase seals Audi Q5 Type 8R (2008-2017)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Audi A2(1999-2005)

This site uses cookies 🍪. Click the button to accept this fact.