Table of contents: 4-cylinder engines ↓ 5-cylinder engines ↓
1. Connect all hoses and check that the heater is turned on in the heating position.
2. Fill the expansion tank with refrigerant to the top, then proceed as follows according to the model.
4-cylinder engines
3. Fill the system until water without air bubbles appears at the fuel injection mode switch (photo), then press the switch. Make the switch wire contact.
4. Fill the expansion tank until the level reaches the minimum mark on the side of the tank.
5. Install the filler cap, start the engine until the cooling fan comes on, then stop the engine.
6. Allow the engine to cool, then top up the expansion tank if necessary. When the engine is cold, the fluid should be at the minimum mark. The level will rise by approximately 20 mm as the engine warms up.
5-cylinder engines
7. Start the engine, add coolant as needed until the level remains constant, then install the expansion tank filler cap.
8. Let the engine run until the cooling fan comes on, then turn it off.
9. When the engine has cooled down, add fluid to the expansion tank until the level reaches the minimum mark on the side of the tank. When the engine is warm, the level should rise by approximately 20 mm.