Table of contents: Models with 4-cylinder engine ↓ Models with 5-cylinder engine ↓
Models with 4-cylinder engine
1. Jack up the front of the car.
2. Place a container under the pump, unscrew the hose bungee connections on the pump body. Remove the sealing gaskets.
3. Remove the three pump pulley mounting bolts, remove the outer half of the pump pulley and remove the drive belt. Remove the adjusting washers and the inner half of the pulley.
4. Remove the front and rear pump mounting bolts, move the hose holder hanger and remove the pump.
5. Installation is carried out in reverse order, replace the hydraulic gaskets of the pipeline coupling seal. Tighten all nuts and bolts to the tightening torque specified in the Specifications, adjust the drive belt tension as described in Chapter 27. Fill and bleed the hydraulic system as described in Chapter 25.
Models with 5-cylinder engine
6. Place a container under the pump, unscrew the three hose bungee connections on the pump body. Remove the sealing gaskets.
7. Remove the hose holder hanger, move the hoses to one side.
8. Loosen the drive belt adjuster and remove the belt from the pump pulley.
9. Unscrew the bolt securing the regulator lever to the engine, remove the pump mounting bolt, and lift the pump.
10. Installation is carried out in reverse order, replace the hydraulic gaskets of the pipeline coupling seal. Tighten all nuts and bolts to the tightening torque specified in the Specifications, adjust the drive belt tension as described in Chapter 27. Fill and bleed the hydraulic system as described in Chapter 25.
