Housing replacement, lamp replacement
In the engine compartment, press down the latch next to the turn signal headlight housing using a screwdriver.
Pull the direction indicator headlight housing forward.
Turn the lamp base slightly to the left and pull it back.
Press the incandescent bulb slightly into the socket, turn it to the left and remove it.
Installation: insert the cartridge into the indicator body and turn it to the right until it stops.
To install the turn signal housing, carefully insert it into the guides on the headlight housing and secure the retainer (fastening tongue).
Left: To separate the direction indicator housing from the headlight housing, press the fastening tab (3) downwards from the engine compartment side using a long screwdriver. Then pull the housing forward out of the guides on the headlight housing (1 and 2).
Right: Removing the turn signal bulb: by turning the socket (2) in the headlight housing (1) to the left, you can remove the socket to replace the bulb (shown here with the headlight housing removed).
The rear lights are located in the trunk lid. The bulb holder (2) can be removed from the light housing (1) by turning it to the left.