Dismantling lamp housings, replacing lamps
1. To remove the right turn signal, remove the air duct.
2. In the engine compartment, next to the headlight housing, open the turn signal safety catch.
3. Press down the mounting tab of the turn signal housing.
4. Pull the turn signal lamp housing forward.
5. Turn the lamp holder slightly to the left and pull it out backwards.
6. Lightly press the incandescent lamp into the socket, turn it to the left and remove it.
7. Installation: Press the socket into the turn signal housing and turn it to the right until it stops.
8. When installing, carefully push the turn signal housing into the guides on the headlight housing and insert the protrusions into the grooves.
9. Close the safety valve.
Tip: The orange turn signal bulbs have a different connection method than the clear bulbs. The two protrusions at the bottom of the socket of these bulbs are not opposite each other, but offset to avoid mistakes.
To remove the direction indicator housing from the headlight housing, move the safety catch (2) to the side and press the mounting tab (1) down.
The housing (3) of the direction indicator with the bulb socket (2) removed. When installing the housing, make sure that the guide tabs (1 and 4) are carefully pushed into the guides in the headlight housing or on the wing.