Order of execution
1. Clean the generator from dirt and dust.
2. Unscrew the fastening screws and remove the voltage regulator with brush holder.
3. Loosen the tie bolts and remove the generator cover from the drive side with the rotor.
4. Lightly clamp the rotor by the pole pieces in a vice and unscrew the pulley fastening nut.
5. Remove the washer, pulley and fan with gaskets. Remove the key from the rotor shaft.
6. Press the rotor out of the alternator cover.
7. Loosen the screws and remove the bearing cover.
8. Press bearing out of alternator cover.
9. Press the bearing off the rotor shaft.
10. Loosen the screw and remove the capacitor.
11. Loosen the nuts and remove the washers, gaskets and insulator.
12. Unscrew the three screws securing the stator winding leads to the rectifier unit and remove the stator from the cover.
13. Loosen the screws and remove the rectifier unit from the cover.
14. Assemble the generator in reverse order.
Visitor comments