Removal and installation the generator bracket (Audi A2)

Table of contents: Removal ↓ Installation ↓

Removal

Remove the generator. Unscrew bolts "1...4" and remove the generator bracket.

Installation

Make sure there is a centering sleeve "arrow" for the generator bracket. Screw in bolts "1" all the way and tighten them crosswise. Tightening torque: Generator bracket to cylinder block: 45 Nm.

The article is a reprint of material from: AudiManual.ru

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Engine repair

Removal and installation the torsional vibration damper
Removal and installation a poly V-belt
Removal and installation the engine mount
Removal and installation engine mounts

Belt Drive Camshaft — Design Description
Removal and installation the timing belt
Removal and installation sealing flanges and flywheel
Replacing the crankshaft seal on the belt pulley side