Removal and installation of sealing flanges and flywheel:
1. Cuff. Replacement, do not lubricate with oil
2. Front seal flange, mounted on centering sleeves
3. The cylinder block is replaced only in assembly with the crankshaft
4. Flywheel, for removal and installation, hold with support -33865. 60 Nm + tighten by 90°. Replace
6. Gasket, do not damage during installation work (don't bend), mounted on centering sleeves
7. Bolt. 15 Nm
8. Rear seal flange with cuff with cylinder block gasket. Before installation, lubricate with sealant; to install, put the guide sleeve from the special tool kit on the crankshaft
Visitor comments