Table of contents: Removal ↓ Installation ↓
Removal
The gearbox is removed. Remove the flywheel. Remove the gasket from the flange and from the centering bushings "arrow".
Unscrew bolts "1...8". Remove the rear sealing flange.
Installation
Carefully remove any remaining sealant from the cylinder block and oil pan. Clean the seating surfaces; there should be no oil or grease on them. Cut off the tube tip at the front mark (hole diameter approx. 2mm). Apply a thin bead of "arrow" sealant to the mating surfaces between the cylinder block and the oil pan.
Apply a thin layer of sealant to the lower seating surface of the flange -shaded area-. The sealing flange must be installed within 5 minutes after applying the sealant.
To install the flange, push it on "2" together with the guide sleeve "1" (inserted into flange) onto the crankshaft. Carefully place the sealing flange onto the centering bushings of the cylinder block.
Tighten the bolts. Further installation is carried out in the reverse order. Install the gasket on the sealing flange and place it on the centering bushings. Install the flywheel. Tightening torque: Sealing flange to cylinder block: 15 Nm.
[Text provided by the online resource: AUDIMANUAL]