Execution order
1. Add to the tank (see fig. Hydraulically operated clutch) fresh brake fluid.
2. Remove the protective cap from the working cylinder bleed valve.
3. Attach the bleeder hose to the valve. Place the other end of the hose in a container with a small amount of brake fluid so that it is in the fluid.
4. Press the clutch pedal several times and hold it down.
5. Open the bleed valve to release air from the system. The presence of air in the system is determined by the appearance of bubbles in the container.
6. Close the bleed valve.
7. Repeat the steps described in points 4–6 until air bubbles stop appearing in the container.
8. Remove the hose from the bleed valve and put on the cap.
9. Add clean brake fluid to the reservoir.
10. Check and, if necessary, adjust the free travel of the clutch pedal (see subsection 7.2.2 or pp. 1–3 of subsection 7.3.1).
(The original version is on the portal audimanual.ru)