Hydraulic clutch drive system:
1. Brake fluid tank
2. Hose
3. Clamp, to remove the line, pull the clamp out until it stops
4. Master cylinder
5. Hexagon nut, 28 Nm, self-locking, always replaceable
6. Clamp, replace only with master cylinder removed
7. Clutch pedal
8. Screw, 28 Nm, 2 pcs.
9. Sealing ring, put on the pipeline connection, install with brake fluid
10. Pipe and hose line
11. Clamp to remove the wire, disconnect the connector.
12. Intermediate element
13. Sealing ring, put on the pipeline connection, install with brake fluid
14. Holder, fixed to the control unit
15. Flange bolt, 25 Nm
16. Clamp, to remove the wire, disconnect the connector
17. Cap
18. Ventilation valve, remove air from the clutch assembly
19. Working cylinder, after installation, adjust the gear shift mechanism
20. Flange bolt, 23 Nm
21. KP.
Pry up the grip "A" in the direction of the "arrow".
Press the drive rod/master cylinder into the lock "A" in the direction of the "arrow"
(The article is a reprint of material from «AudiManual.ru»)