1 Bolt, 25 Nm
2 Oil filter base
3 O-ring
4 Oil cooler
5 Nut, 25 Nm
6 Oil filter
All engines use an oil cooler to cool the engine oil, which is installed between the oil filter base and the filter. The oil cooler can be removed after removing the air filter and disconnecting the hoses. The coolant must be drained from the cooling system, as otherwise it will spill out of the hoses. To do this, remove the nut at the bottom.
The oil cooler is sealed on the plinth with an O-ring. When tightening the nut, tighten it to 25 Nm.
Visitor comments