This device must be connected to the W terminal of the generator.
On the front shoulder of the crankshaft belt pulley, make a white mark with chalk 1-2 cm wide.
Warm up the engine to operating temperature (oil temperature should be 50-70°C).
Pull out the cable of the device to facilitate starting a cold engine.
Consumers of electric current must be turned off (radio, light).
Using a tachometer, determine the number of revolutions.
Loosen the adjusting screw locknut.
2.4L engine
Using the idle speed adjusting screw, set the speed to 850±10 rpm.
Attention: The idle speed must be adjusted very precisely.
Lock the adjusting screw and varnish.
Visitor comments