4-cylinder engines (Mono-Motronic and Digifant)
Loosen the bandage on the air intake sleeve. Remove sleeve.
Open the clamps around the filter housing.
Remove the cover, remove the filter element.
Vacuum hoses may remain connected.
5-cylinder and 4-cylinder engines (KE-Motronic)
Remove the inlet cap above the fuel mixture adjuster.
Remove a total of four retaining clips around the air filter housing.
Press the air ratio corrector together with the upper part of the air filter housing against the engine. Now you can remove the replacement element.
If necessary, unscrew fuel lines that interfere with work and move them aside.
Models with 6-cylinder engine
On the 2.8 liter engine, remove the air mass meter plugs.
Remove the bandage on the air intake sleeve. Remove sleeve.
Open the clamps around the filter housing.
Remove the cover, remove the filter element.
Removing the air filter pump
Remove housing cover (with corrector of the composition of the combustible mixture) and a replaceable air filter element.
Disconnect the heated air hose of the intake air heating system.
Loosen the hex bolt at the base of the container.
Remove the retaining pin of the filter housing from the rubber bushing on the wheel arch.
Remove body.
Visitor comments