Carburetor models (and PM engine with Mono-Jetronic system)
2. Unfasten the spring clips on the air filter cover. Unscrew the single screw and remove the cover from the air filter housing (photo).
3. Remove the air filter element.
4. Wipe off the air filter housing and cover.
5. Position the new element in the housing, then install the cover. Insert and tighten the single screw and snap the spring clips.
Fuel injected models (except for the RM engine)
6. Loosen the rubber strap in the right front corner of the engine compartment, then remove the intake cover and disconnect the intake hose (photo).
7. Loosen the screw and remove the side cover (photo).
8. Release the spring clips securing the air filter cover, lift the cover out of the airflow meter (photo).
9. Remove the air filter element from the main body.
10. Wipe the inside of the air filter housing and cover.
11. Position the new element in the housing, then install the cover, snap the spring clips into place.
12 Install the side cover, inlet hose, and inlet cover.
Visitor comments