For removing heating and ventilation (Audi 100 C4)

Audi recommends making your own small hooks from 3mm wire, with the end bent to 6mm.

Nozzle on the top left: pry the grille out of the air duct manually.

Nozzle on the left in the middle: insert the hooks for removing the grille approximately in the middle of the nozzle grille and remove the nozzle.

Nozzle bottom left: remove nozzle on left middle.

Unhook the retaining springs and remove the nozzle.

Nozzle in the middle of the instrument panel: remove the plugs on the right and left of the switch strip using a small screwdriver.

Insert a screwdriver under the nozzle body and push the nozzle forward.

Nozzle on the top right: remove the nozzle grille and remove it from the air duct with your hand.

In the adjustable nozzle, make sure that the pin of the regulator button fits exactly into the groove when installing.

Bottom right: Insert the nozzle extraction hooks approximately in the middle of the grille and remove the nozzle.

Nozzle at the back in the center console: bend the trim of the center console forward a little.

Loosen the Phillips head screw underneath.

Remove the panel around the cigarette lighter with a narrow screwdriver.

There are 2 Phillips head screws underneath: remove.

Remove the nozzle with your hand.

[This article was previously published on the resource: audimanual.ru]