Gearshift control mechanism for vehicles produced since August 1988
- 1 - selector lever handle;
- 2 - casing;
- 3 - protective cover;
- 4 - selector lever block;
- 5 - electromagnetic switch for blocking the selector lever;
- 6 - spring;
- 7 - bushing;
- 8 - selector lever;
- 9 - spring;
- 10 - axis of the intermediate lever;
- 11 - intermediate lever;
- 12 - bushing;
- 13 - selector cable seal;
- 14 - mechanism case;
- 15 - cable;
- 16 - cable bracket
Examination
1. Unscrew knob 1 of selector lever.
2. Loosen the mounting bolts and remove the cover 2.
3. Remove protective cover 3.
4. Set selector lever 8 to position «R».
5. Check with a flat feeler gauge 2 and, if necessary, adjust the gap between the contact of the selector lever lock electromagnetic switch 3 and the selector lever 1, which should be equal to 1 mm.
6. Install protective cover 3.
7. Install casing 2 and tighten the bolts of its fastening.
8. Screw knob 1 onto selector lever.
Visitor comments