Removal and installation the function selector switch (Audi A2)

Table of contents: Removal ↓ Installation ↓

Removal

Switch off the ignition and remove the ignition key. Remove the rear section of the center console. Unlock the fastening brackets "arrows". Press the function selection switch 2 "E272" out of the center console.

Installation

Installation is in reverse order, but it is necessary to install the rear part of the center console.

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Breakers and switches

Removal and installation the glove box light switch
Removal and installation center console switches
Removal and installation front seat heating switches
Removal and installation the hazard warning switch

Removal and installation the rear view mirror adjustment switch
Switch module with front left window switch
Front passenger door window switch
Removal and installation the rear door window switch

Similar articles on other Audi car models:
Brake light switch — removal and installation Audi 80 B3 (1986-1991, petrol)
Combination switch — removal and installation Audi 100 C3 (1982-1990, diesel)
Removal and installation the gear selector housing Audi A3 Type 8L (1996-2003)
Removal and installation the light switch Audi A4 B6 (2000-2006)
Ignition switch — removal and installation Audi A6 C5 Allroad (1999-2005)
Removal and installation the engine Audi A8 D2 (1994-2002)
Removal the selector position switch P «F305» Audi Q5 Type 8R (2008-2017)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Audi A2(1999-2005)