Adjusting the length of the connecting rail
- 1 - roller bracket;
- 2 - rack drive lever;
- 3 - rod;
- 4 - connecting rail;
- 5 - adjusting bolt
The connecting rail must be adjusted if the idle speed was adjusted.
Execution order
1. Warm up the engine. The oil temperature should not be below +70°C.
2. Turn the lever so that the hole in the lever coincides with the hole in the bracket.
3. Fix the lever by inserting a rod with a diameter of 3.5 mm into the holes of the lever and bracket (for example, a drill).
4. Loosen the bolt and set the rack length so that the fuel pump lever touches the limiter.
5. Tighten the bolt and remove the rod.
(The original article is available on the website: audimanual.ru)