Replacement of the reflective element of the mirror with a mechanical drive
- 1 - body;
- 2 - adjusting slider;
- 3 - reflective element;
- 4 - spring;
- 5 - latch
Order of execution
Manual drive
1. Pry from below with a plastic or wooden spatula and use a hard plastic wedge or a narrow screwdriver to turn the reflective mirror element towards the door.
2. Disconnect the spring from the reflective element.
3. Push the latch clips down and remove the reflective element from the adjusting mechanism.
4. Install the reflective element in the latch.
5. Connect the spring to the reflective element.
6. Rotate the reflective element to its previous position and carefully press it onto the ball pin, applying force only to the central part of the element.
Electric drive with current heating
7. Rotate through the mounting hole on the bottom of the case (1) mirror snap ring (2) in the direction of the car, thereby unlocking the reflective element.
8. Carefully remove the reflective element by disconnecting the heating wires from it.
9. Connect the wires of the heating system to the reflective element.
10. Insert the reflective element into the mirror housing and fix it with the retaining ring. In this case, the pin on the retaining ring must be in the middle of the mounting hole.
Visitor comments