Table of contents: Removal ↓ Installation ↓
Removal
Remove the mirror glass 7 (fig. 12.64). Loosen the three screws securing the adjustment mechanism.
Fig. 12.64. Outside rearview mirror
1 - mirror housing,
Can be removed with the mirror installed.
2 - mirror position adjustment mechanism,
3 - door frame,
4 - bolt, 12 Nm,
5 - seal,
6 - screw,
7 - mirror glass,
8 - friction pin,
9 - friction spring.
Remove the electrical wires. If the wires are soldered, mark their connections and disconnect the wires directly in the case.
Installation
Installation is carried out in the reverse order of removal.
This article was previously published on the resource AudiManual.ru