The idle handle or setting disc must not exceed 90°.
Install the glass parallel to the mirror body.
Pull off the setting buttons.
Use a small screwdriver to turn the set screws as follows:
1. Turn the adjusting screw -AI- to the right until a slight resistance appears.
2. Turn the opposite screw -AH- to the left until a slight resistance appears.
3. Turn the screws -BI- and -BII- in the same way as shown in the figure. The figure shows the adjustment of the exterior mirror on the driver's side.
Attention: If the adjustment torques are too high, the mirror control will require more effort.
Visitor comments