Removal
Remove the sunroof plugs. Use a T25 screwdriver to unscrew the bolts, arrows (fig. 12.59) on both sides. Lift the cover up.
Installation
Replace the sliding sunroof and secure with bolts, tightening them to a torque of 4.5±0.5 Nm.
Install the plugs.
Adjustment
To eliminate wind noise, the height adjustment of the sliding sunroof should correspond to Figure 12.60.
Check the adjustment of the sliding sunroof at the ends of the roof cutout radii in relation to the middle of the vehicle. The sliding sunroof should not be higher or lower than the roof at any point.