Table of contents: Removal the sliding sunroof control… ↓ Installation ↓ Removal the sunblind control unit… ↓ Installation ↓
Removal the sliding sunroof control unit "J245"
Remove the sliding sunroof position regulator "E139". Remove all connectors from the sliding sunroof control unit "J245". Unscrew the sunroof electric motor bolts and remove the sunroof control unit "J245" from the cutout in the roof.
Installation
Insert the sunroof control unit "J245" "2" and tighten the "arrow" bolts (3.5 N·m). Connect connector "1" of the sunroof electric motor "2".
Install the ceiling panel. After completing all work, initialize the electric motor of the sliding sunroof.
Removal the sunblind control unit "J394"
Remove the headlining. Remove the connector "1" of the sunshade control unit "J394" "2". Unscrew the "arrow" bolts of the sunblind control unit "J394-2". Remove the sunblind control unit "J394-2".
Installation
Installation in reverse order. Before installing the sunroof curtain motor, measure the distance "dimension a" between mirror "1" and cassette "2" and install the sunroof curtain parallel.
Tightening torque: Bolts: 3.5 Nm. After completing the work, perform the normalization of the hatch electric motor.
The original article is located on the online resource: AUDImanual