Removal and installation of the cable engagement device
Disconnect the front push rod from the reverse fork axle.
Remove the front push rod by pulling it under the cable engagement device.
Loosen the bracket bolt.
Hang the bracket over the cable hook using a wire hook.
Note. Removing the cable engagement device is possible only after removing the gearbox.
Install the device in the reverse order of removal.
Scheme of the passive safety system «PROCON-TEN»: System «PROCON-TEN» ensures that in the event of a frontal collision, the steering column retracts to block the seat belts. It consists of three steel cables, transmission and retention links, a collapsible steering column, which is a corrugated pipe, and two tensioners on the front seat belt reels. The upper end of one cable is fixed to the steering shaft, the lower end is passed around the gearbox and fixed to the body. The other two cables are placed in the same way and are attached to the two reels of the front seat belts. Depending on the strength of the collision, there is a certain shift in the relative position of the power unit, gearbox and body. This shift drives the system «PROCON-TEN»
Visitor comments