The regulator is controlled by a sliding contact and a key located on the turn signal lever (see photo).
To activate the speed controller, set the sliding contact "A" opposite the inscription "EIN". Once the desired speed is reached, to maintain it, it is sufficient to briefly press the button "B" on the end of the turn signal lever, then remove your foot from the gas pedal.
If you need to increase the speed of movement, simply press the "B" key and hold it down until the desired speed is reached.
If the speed increase is achieved by pressing the accelerator pedal, the previously programmed speed will be restored when the pedal is released.
When the brake pedal or clutch pedal is pressed, the regulator is temporarily switched off. Switching off of the regulator also occurs when the sliding contact is moved to the right, without passing the point of more rigid resistance. The previously programmed speed is saved in memory in these cases, and to restore it, it is enough to move the sliding contact "A" to the stop to the left opposite the inscription "AUFN" and release the brake or clutch pedal beforehand.
The speed controller is completely switched off when the sliding contact is moved to the right until it stops at the "AUS" position or when the ignition is turned off.
A - Outdoor lighting switch (photo)
- Position 0 - Lighting off;
- Position 1 - Side lights;
- Position 2 - Low or high beam.
The headlights only work when the ignition is on. When the ignition is turned off, the headlights automatically switch back to parking lights.
B — Light signal switch lever
The light signaling works only when the ignition is on.
- Right turn - lever up;
- Left turn - lever down.
When the turn signal is on, the turn signal indicator lamp flashes.
- High beam headlights - lever away from you;
- Low beam headlights - pull the lever towards you.
The side lights only light when the ignition is off.
- Right sidelights - lever up;
- Left side lights - lever down.
C — Hazard warning light switch (photo)
To turn on the hazard warning lights, lift lever "C" up.
When the hazard warning lights are switched on, the indicator lamp starts flashing.
The hazard warning lights also function when the ignition is off.
D — Windscreen wiper and washer switch lever
Windscreen wipers and washers operate only when the ignition is on.
The lever can occupy the following positions (see photo):
- 0 — initial position. Windscreen wipers and washers are off.
- 1 — Intermittent windshield wiper mode. Windshield wipers operate at 5-second intervals.
- 2 - Slow speed windshield wiper mode.
- 3 - Fast windshield wiper speed mode.
The washer operates when the lever is pressed towards the steering wheel.
When the lever is released, the washers continue to operate for approximately 4 seconds.
Rear window wiper and washer (Avant)
The rear window wiper is activated by briefly pressing the lever on the steering wheel; the wiper operates for approximately 4 seconds.
The headlight washers and washers operate when the headlights and windshield washers are on.