Front seat
1. Push the seat all the way back.
2. Remove the screw where present, spread the trim piece away from the seat jogger.
3. Pry open the cover from the side section of the seat jogger.
4. Loosen the lock nut on the front of the seat.
5. Pull the seat back out of the joggers. Remove it through the door opening.
6. If electrically operated front seats are installed, disconnect the negative battery cable and remove the bolts securing the seat frame to the floor.
Back seat
7. To remove the gasket, remove two screws, one on each side below the front edge, lift the gasket from the front, spread it up.
8. To remove the seat back on models "sedan", remove the gasket, unscrew the two screws on the bottom of the seatback, lift it up and remove it.
9. To remove the seat back on models "station wagon", remove the trim to access the hinges.
10. Turn off bolts of fastening of the hinge, remove a sitting back from the car.
11. Installation is carried out in the reverse order.
Visitor comments