Windshield wiper
- 1 - brush;
- 2 - brush lever;
- 3 - cap;
- 4 - nut;
- 5 - spring washer;
- 6 - bracket;
- 7 - drive thrust;
- 8 - lever;
- 9 - bolt;
- 10 - wiper motor;
- 11 - windshield washer jet;
- 12 - valve;
- 13 - washer hose bracket;
- 14 - windshield washer motor;
- 15 - windshield washer reservoir;
- 16 - water level sensor in the tank;
- 17 - bolt
Order of execution
1. Open the hood.
2. Disconnect wire from «negative» battery terminals.
3. Pry off with a screwdriver and remove the protective caps from the wiper arms.
4. Open not completely (so as not to spoil the thread on the rollers) wiper arm nuts. Using pliers, pull off both levers from the splines of the wiper mechanism rollers and, having completely unscrewed the nuts, remove the levers.
5. Remove protective cover.
6. Disconnect wires from wiper motor.
7. Loosen one bolt on each side of the wiper arms.
8. Disconnect the bracket mounting bolt and remove the wiper mechanism assembly.
9. Install windshield wiper in reverse order. In this case, tighten the bracket fastening bolt to a torque of 4 Nm (0.4 kgf·m), and the support bolts - with a torque of 7 N·m (0.7 kgf·m).
10. Set the wiper arms so that the blades at rest are parallel to the tangent line of the windshield contour.
Visitor comments